If communication blocks for 'N' * 1/10 seconds, DRBD falls back into unconnected operation.
If this field is left blank the internal DRBD default will be used instead.
The synchronisations sends up to 'N' KB per sec.
If this field is left blank the internal DRBD default will be used instead.
Sets the size of the transfer log(=TL). The TL is is used for dependency analysis. For long latency high bandwith links it might be necessary to set the size bigger than 256. You will see error messages in the system log if the TL is too small.
If this field is left blank the internal DRBD default will be used instead.
Sets drbd's size. When set to 0 drbd negotiates the size with the remote node. A value different from 0 will allow drbd to operate even without a connection to the other node. Make sure sizes match!
If this field is left blank the internal DRBD default will be used instead.
Instruct DRBD not to do synchronisation.
DRBD will trigger a kernel panic if there is an IO error on the lower_device.
May be usefull when DRBD is used in a HA cluster.
Protocol used for this device
Protocol may be A, B or C.